C
o
n
f
i
g
u
r
a
t
i
C
o
n
f
i
g
u
r
a
t
i
To use Telnet for managing Master/Slave device, refer to the following sections.
Default IP Settings for Master Device
1. The default IP address of Outband (MGN port):
172.16.1.1/255.255.255.0)
2. IP address for Inband (UPLINK port): 0.0.0.0
(disable)
How to Change Master IP Setting
Changing master IP address setting (for management) is allowed to suit environment requirement.
Type the command below to change the settings.
For Outband (MGN port connection) , please set as the following
-
Admin>network out <new-ip> <mask> [vlanid]
For Inband (UPLINK port connection) , please set as the following
-
Admin>network in <new-ip> <mask> [vlanid]
For the Status, please set as the following
-
Admin>network out or - Admin>network in
Note: The IP addresses for MGN port and UPLINK ports cannot belong to the same domain.
How to Change Slave IP Setting
Changing IVD IP address setting (for management) is allowed to suit environment requirement.
Type the command below to change the settings.
For MGN/UP port connection , please set as the following
-
IVD>network staticIP <ip> <netmask> <gateway>
Note:It is applied below version V1.0.1.7, MGN and UP will be different when the
version is above V1.0.1.7.
For the Status, please set as the following
- IVD>network staticIP -s
How to Configure IP Address for Slave-Standalone DSL module
A slave device can work alone without connecting the master device. The device with one Gigabit
Ethernet interface version.
For one gigabit-ethernet interface version, please set as the following
-
$ipconfig <ip> <mask>
How to Login with Telnet
For Master/Slave Device
1. Make sure the device IP has been configured well.
2. Make sure the connection between MGN port (for outband) and UPLINK port (for inband).
3. Open Telnet command screen.
4. Username/Password
-
admin/1234
Now, please use Telnet commands to manage the master/slave device for your necessity.
6
o
n
b
y
U
s
i
n
g
T
e
l
n
e
o
n
b
y
U
s
i
n
g
T
e
l
n
e
(type 'exit' to return)
t
t
Default IP Settings for Slave Device
1. The default IP address of Outband (MGN port):
172.16.1.2/255.255.255.0)
2. IP address for Inband (UPLINK port): 0.0.0.0
(disable)
Quick Start Guide for VigorAccess IVD
Version: 1.2