Table of Contents
Advertisement
$modify stp info enable
$modify stp port info portid
<bridge-port-id> enable
$get stp port info portid
<bridge-port-id>
How to Enable IGMP Snooping
Users can use the following command to enable IGMP snooping. The commands are listed as below. Be
aware that IGMP Snooping is the Factory Default Setting.
Command
$create filter rule entry ruleid <id>
action sendtocontrol description IGMP
$create filter subrule ip ruleid <id>
subruleid 1 prototypefrom 2
prototypecmp eq
$modify filter rule entry ruleid <id>
status enable
$create filter rule map ifname all
ruleid <id> stageid 1
$modify igmpsnoop cfg info status
enable
$modify igmpsnoop port info portid
<bridge-port-id> status enable
leavemode fastNormal
or
$modify igmpsnoop port info portid
<bridge-port-id> status enable
leavemode Fast
How to Upgrade Control Plane Code Remotely
Users can use the following command to remotely upgrade control plane code. Make sure you have
prepared TFTP server, vendor supplied CP.bin.gz , and put CP.bin.gz into root directory of TFTP server.
The commands are listed as below.
Command
$firmware upgrade [-]<source file>
<CP|DP|FD|DSL|ALL> <server ip>
Quick Start Guide for VigorAccess
Enable STP globally
Bridge port id: 1~193
Description
The feature is enabled in default.
Description
Upgrade the control plane code
Version: 1.2
15
Advertisement
Table of Contents
