Honeywell NOTIFIER SCS Series Operation And Installation Manual page 76

The SCS⁄SCE
Annunciator
Address 2
field set to
FSCS
ANNUNCIATOR
TYPE soft key
POINT PROGRAMMING soft key

Soft Keys
ANNUNCIATOR TYPE:
When the smoke control modules are set for FSCS mode, points 65 through 96 are automatically generated for use in FSCS mode prioritiza-
tion.
ACCEPT:
Press to save the entry.
POINT PROGRAMMING:
to assign a mode and source to each annunciator point at the annunciator address.
POINT
soft key
MODE
soft key
SOURCE
soft key
NEXT POINT and
PREVIOUS
POINT soft keys

Soft Keys
POINT:
Press this soft key to enter the ACS point number. The format is AxxPyy, where xx is the two-digit annunciator address, and yy is
the two-digit annunciator point number. Note that "Unneeded" points require no programming and may be skipped.
MODE:
Press until the desired mode appears onscreen. The mode must be MONITOR for a "Needed" point being mapped to a monitor
module, and CONTROL for a "Needed" point being mapped to a control module. The mode for "Unused" annunciator points must be CON-
TROL, witha SOURCE entry of a valid unused control point (See SOURCE below). All "Unused" annunciator points can reference the
same control point.
76
A C S P R O G R A M M I N G
A 0 1 : U D A C T
A 0 5 : N O
A 0 9 : N O
A 1 3 : N O
A 1 7 : N O
A 2 1 : N O
A 2 5 : N O
A 2 9 : N O
A N N U N C I A T O R T Y P E
P O I N T P R O G R A M M I N G
Figure 3.28 ACS Programming Address Screen, NFS2-3030 and NCA-2
Press until "FSCS" or "HVAC" appears in the field (the underlined area) to the right of the address. Note:
Press to bring up the ACS Point Programming screen. The point programming screen allows the programmer
A C S P R O G R A M M I N G
P O I N T : A 0 2 P 0 1
M O D E : C O N T R O L
S O U R C E : N 0 0 3 L 0 1 M 0 0 1
N E X T P O I N T
P R E V I O U S P O I N T
Figure 3.29 ACS Point Programming Screen, NFS2-3030 and NCA-2
A 0 2 : F S C S A 0 3 : 9 6 P T
A 0 6 : N O A 0 7 : N O
A 1 0 : N O A 1 1 : N O
A 1 4 : N O A 1 5 : N O
A 1 8 : N O A 1 9 : N O
A 2 2 : N O A 2 3 : N O
A 2 6 : N O A 2 7 : N O
A 3 0 : N O A 3 1 : N O
A 0 4 : T M 4
A 0 8 : N O
A 1 2 : N O
A 1 6 : N O
A 2 0 : N O
A 2 4 : N O
A 2 8 : N O
A 3 2 : N O
A C C E P T
B A C K
ACCEPT soft key
A C C E P T
B A C K
ACCEPT soft
SCS Series Manual — P/N 15712:L 7/18/16
Programming
SAVE or
key