Ratings and Wiring Diagrams
1b listed
contact
1a listed
contact
Pneumatic
Tubing
PRESSURE
SWITCH
Power
Return
Figure 5.39 depicts an EP damper in a non-dedicated system with the capability of
state, switch group type 8. In the above configuration, the CON
CON
CM controls a normally closed contactor for the pressure switch power line. When the CON
ON⁄OP
closed contactor is opened. When the contactor opens, power is cut from the pressure switch, which allows airflow to open the damper.
When the CON
ON⁄OP
CON
CM.
ON⁄OP
When power is cut from the pressure switch, the damper opens. When the damper completely opens, the damper open limit switch is
, indicating that the damper is in the
CLOSED
switch. In this case the VER
148
Energy
Management
System
CON
CM
ON/OP
(activated)
FRM-1
Power
Source
(use 3.9K listed ELR with FZM-1)
Airflow
SMOKE
DAMPER
OPEN
Figure 5.39 EP Damper Control, Non-dedicated System - FSCS Switch Group Type 8
CM is deactivated, the EMS is free to control the damper. The EMS is currently being overridden by the
OPEN
MM is activated because the damper is
ON⁄OP
Listed
24 VDC
Power Source
ELR-47K
Limit Switch
for open
position
N/O
COM
CM is activated and the CON
ON⁄OP
position. The VER
MM monitors the
ON⁄OP
.
OPEN
Non-dedicated Smoke Control System Wiring Diagrams
CON
CM
OFF/CL
(deactivated)
FCM-1
VER
MM
ON⁄OP
(activated)
FMM-1
SLC Loop
and
control and verification of the
OPEN
CLOSED
CM is deactivated. The
OFF⁄CL
CM is activated, the normally
ON⁄OP
position of the damper closed limit
CLOSED
SCS Series Manual — P/N 15712:L 7/18/16
*If the SLC device
does not match the
one in this figure,
refer to the SLC
manual appendix,
which contains
wiring conversion
charts for type V
and type H
modules.
OPEN