Honeywell NOTIFIER SCS Series Operation And Installation Manual page 67

Configuration
1
No Function - Factory Setting
2
1 1
1 1
1 1
1 1
SCS-8
3
2 2
2 2
2 2
2 2
SCS-8
4
3 3
3 3
3 3
3 3
SCS-8
5
4 4
4 4
4 4
4 4
SCS-8
6
5 5
5 5
5 5
5 5
SCS-8
7
6 6
6 6
6 6
6 6
SCS-8
SCS Series Manual — P/N 15712:L 7/18/16
The SCE will not function with dipswitches selected
as shown on the right. This is a factory setting that
must be changed in order for the SCS to function
properly.
When used with an SCE, all 16 switch groups are
available for group type 1 operation. Type 1 switch
1 1
groups require one monitor module. Type 1 switch
1 1
groups can be used for fans or dampers. The monitor
1 1
module is used for the OFF verification of the fan.
1 1
SCE-8
When used with an SCE, all 16 switch groups are
available for group type 2 operation. Type 2 switch
2 2
groups require one monitor module. Type 2 switch
2 2
groups can be used for fans or dampers. The monitor
2 2
module is used for the ON verification of the fan.
2 2
SCE-8
When used with an SCE, all 16 switch groups are
available for group type 3 operation. Type 3 switch
3 3
groups require two monitor modules. Type 3 switch
3 3
groups are usually only used for dampers. One
3 3
monitor module is used for the OPEN verification of
3 3
the damper and the other monitor module is used for the CLOSED verification of the damper.
SCE-8
When used with an SCE, all 16 switch groups are
available for group type 4 operation. Type 4 switch
4 4
groups require one control module. Type 4 switch
4 4
groups can be used for fans or dampers. The control
4 4
module is used for OFF control of a fan.
4 4
SCE-8
When used with an SCE, all 16 switch groups are
available for group type 5 operation. Type 5 switch
5 5
groups require one control module and one monitor
5 5
module. Type 5 switch groups can be used for fans or
5 5
dampers. The control module is used for OFF control
5 5
of a fan and the monitor module is used for the OFF verification of the fan.
SCE-8
When used with an SCE, all 16 switch groups are
available for group type 6 operation. Type 6 switch
6 6
groups require one control module and one monitor
6 6
module. Type 6 switch groups can be used for fans or
6 6
dampers. The control module is used for OFF control
6 6
of a fan and the monitor module is used for the ON verification of the fan.
SCE-8
Table 3.10 HVAC Mode Dipswitch Settings (1 of 5)
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
The SCS⁄SCE
67