Table of Contents
Advertisement
Operating Instructions MB TouchScreen ControlPanel
7.1.6 Clear part
Clear all triggered detector groups and faults in this alarm partition.
For this function, an additional code entry may be required as an operating release.
7.1.7 Installer information
Display of a freely programmable text during central programming (e.g. name and address of the
installer, telephone number, etc.).
7.1.8 Test
The operating menue is used to switch on the walk test for the alarm partition, the cleaning mode
for the screen and to display the ID data code of an ID data carrier held in the reading field of the
TouchScreen ControlPanel.
Walktest
Press the button to
switch on the walk test
Walktest switched off
The walk test is switched off by arming/disarming the alarm partition, too.
Clean display
Press the button to
start display cleaning
Start clean display
RFID-Code
Hold the ID data carrier in the reading field of the TouchScreen ControlPanel. Display
7.1.9 Activation of access level 3
After receiving the normal operating authorisation, the operating authorisation for access level 3
can be entered after pressing this button. This can be done by entering a code or by presenting an
authorised data carrier to the integrated reader. This button is not usually displayed, only if it has
been programmed accordingly in the panel.
Press the button to
switch off the walk test
Walk test in progress
Button change
Press the button
start display cleaning
Information text
Display changes
Walktest switched off
Button change
è
Continue
Display is disabled for
30 seconds.
Display changes
11
è
Code
Advertisement
Table of Contents
