Adjusting The Cut Height; Switching On And Off; Level Gauge; Working With The Lawnmower - Grizzly ERM 1641 GT Translation Of The Original Instructions For Use

GB

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
Hold the cutting height adjuster
(11) and move it to the correct cut-
ting height, as appropriate.
The equipment has 7 positions for
adjusting the cut height: 30 - 75 mm
The correct height is around 30 – 45 mm
for a decorative lawn and around
30 –65 mm for a used lawn.
A higher cut height should be se-
lected for the first cut of the season.

Switching On and Off

1. Connect the mains cable (16)
with the extension cable.
2. Turn the end of the extension
cable into a loop and hook it into
the cable strain relief (19).
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
5. To switch on, press
the release button
(18) on the handle
at the same time as
pressing the start lever (2). Re-
lease the release button (18).
6. To switch off, re-
lease the start lever
(2).
26
STOP START
I
3 2
STOP
3
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do not
touch the moving blade. There
is a risk of injury.

Level gauge

The level gauge (
the side of the grass catcher (
aerodynamic air guidance provided by the
flap also optimises the filling.
Flap open:
grass catcher empty
Flap closed:
grass catcher full

Working with the Lawnmower

Regular mowing encourages increased
foliation of the grass and kills off weeds at
the same time. Therefore, not only does
each mowing increase the density of the
lawn, it also produces an evenly resilient
lawn.
When mulch mowing the grass is cut in
one cycle, finely chopped and distributed
on the lawn. The cut grass acts as a natu-
ral fertilizer.
• Start mowing near the socket and
work away from the socket.
1
• Always keep the extension cable be-
hind you and when you turn, move it to
the side that has already been mowed.
• Run the equipment at a walking pace,
in tracks that are as even as possible.
START
For gap-free mowing, the tracks should
1
I
always overlap by a few centimetres.
2
• Adjust the cut height so the equipment
is not overloaded. Otherwise, the mo-
tor may be damaged.
15) is located on
7). The