Assembling The Grass Box; Operation; Hanging On / Removing The Grass Box; Adjusting The Cut Height - Grizzly ERM 1233 G Translation Of The Original Instructions For Use

GB

Assembling the Grass Box

Wear protective gloves when
carrying out maintenance and
cleaning work on the tool to avoid
injury from cuts.
D
1. Connect the two pieces of the
collection box (16).
2. Connect the handle (15) in one
of the two pieces of the collec-
tion box (16).
Do not work with the lawnmower
without the collision guard or lawn
box. There is a risk of injury.

Operation

Hanging On / Removing the
Grass Box
E 1. To hang on the grass box (4), lift
the collision guard (7) and hang
on the grass box. Fold the col-
lision guard (7) onto the grass
box (4). It holds the grass box in
the correct position.
2. To remove the grass box (4),
lift the collision guard (7) and
detach the grass box. Fold the
collision guard (7) back onto the
mower housing (6).

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
The lawn mower can be adjusted to the
following cutting heights by changing the
position of the wheels:
44
60 mm - Tall cutting height
40 mm - Medium cutting height
20 mm - Short cutting height
1. Reach under the body of the lawn
mower (6) and pull the wheel axle to-
wards you.
2. While pulled, the wheel axle can be
moved up or down to any of the three
cutting heights.
3. If the height is correct, just let go of
the spring-loaded wheel axle to let it
snap back into working position.
The correct height is around 20 � 40 mm
for a decorative lawn and around 40 � 60
mm for a used lawn.
A higher cut height should be se-
lected for the first cut of the season.
Observe the noise protection and
local regulations.

Switching On and Off

1. Insert the power cable plug into
the socket (9) on the curved
handle (1).
2. To relieve the strain, form a loop
with the end of the power cable
and hang this into the strain re-
lief (11). See the diagram
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
5. To switch on, press the release
button (10) on the handle at the
same time as pressing the start
lever (12). Release the release
button (10).
6. To switch off, release the start
.