Installing The Grass Catcher; Operation; Mounting / Removing The Grass Catcher; Adjusting The Cut Height - Grizzly ERM 1637 G Translation Of The Original Instructions For Use

GB

Installing the grass catcher

Assemble the grass catcher:

Clip the rubber lip of the grass
catcher net (19) into the hard
plastic tray of the grass catcher
(9).
‚
Insert the linkage tubes (19) into
the grass catcher net (20). Make
sure to fully insert the tubes (see
ill. detail).
The tube bows fit into the
groove (21) at the bottom of the
grass catcher
ƒ
Pull the plastic straps (22) over
the linkage tubes (20).
„
Use the screws and washers
(23) from the package to mount
the linkage tubes (20).

Operation

Attention: Do not operate the ap-
pliance until the collision guard
and grass catcher are fully in-
stalled. Risk of injury!
Mounting / removing the grass
catcher
1. Lift the collision guard (5).
2. Place the grass catcher (7) on the
mounting bracket (24) provided at
the back of the lawn mower.
3. Lower the collision guard (5)
onto the grass catcher (7) - it
will keep it in place.
4. To remove the grass catcher
(7), lift the collision guard (5)
and unhook the grass catcher
from the mounting bracket. Flap
down the collision guard to the
housing.
24
On emptying the grass catcher
also refer to section "Disposal/en-
vironment".

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
Hold the cutting height adjuster
(11) and move it to the correct cut-
ting height, as appropriate.
There are six different cutting heights:
25 - 35 - 45 - 55 - 65 - 75 mm
The correct height is around 30 – 45 mm
for a decorative lawn and around
30 –65 mm for a used lawn.
A higher cut height should be se-
lected for the first cut of the season.

Switching On and Off

1. Plug the mains lead (18) into
the appliance's power inlet (17).
2. Turn the end of the mains lead
into a loop and hook it into the
cable strain relief (14).
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
5. To switch on, press
the release button
(16) on the handle
at the same time
as pressing the start lever (2).
Release the release button (16).
6. To switch off, release the start
lever (2).
1
2