Attachment Of The Pedals; Radiation Shield Assembly And Installation - GE Alpha RT 32551 Installation Instructions Manual

3 Installation
3.7 A
TTACHMENT OF THE PEDALS
Plug in the footpedals to the connection box in the back of the column.
See figure 3.11, Connectors for the pedals.
Fig 3.11. Connectors for the pedals
3.8 R
ADIATION SHIELD ASSEMBLY AND INSTALLATION
Preparations:
Identify how the Alpha RT unit is mounted - on stationary base plate or
wall mounted. If the unit is wall mounted, the wall mount base plate is
provided with holes for the hinge support pieces (Fig. 3.12, Wall mount
base plate and hinge support plate).
Instructions:
Open the crate and compare the contents to the packing list. If the
stationary base plate is used, locate the hole provided for the hinge in
base the plate. Drop the sleeve in a hole mount.
Left or right side installation:
1 Press the other plastic sleeve into the large hole on the upper hinge
bracket.
2 Screw the bracket with M6 screws (2) on top of the column.
3 Put the lower hinge pin into the bottom sleeve.
4 Lift the shield into position, and put the upper pin through the upper
hinge bracket into the hinge on the shield.
5 Swing the shield into the desired position. Loosen the shield stop and
lower it until it contacts the floor.
6 Tighten the stop screws. If the wheel is used the adjustment is not
needed.
28 GE Healthcare
Fig 3.12. Wall mount base plate
and hinge support plate
32551-IMG rev 6