Adjust The Handset Rest; Connect To The Network - Cisco 6851 Series User Manual

Adjust the Handset Rest

If your phone is wall-mounted or if the handset slips out of the cradle too easily, you may need to adjust the
handset rest to ensure that the receiver does not slip out of the cradle.
Procedure
Step 1 Remove the handset from the cradle and pull the plastic tab from the handset rest.
Step 2 Rotate the tab 180 degrees.
Step 3 Hold the tab between two fingers, with the corner notches facing you.
Step 4 Line up the tab with the slot in the cradle and press the tab evenly into the slot. An extension protrudes
from the top of the rotated tab.
Step 5 Return the handset to the handset rest.

Connect to the Network

You need to connect the phone to the telephone network.
• Wired connection—the phone is plugged into the network using an Ethernet cable.
3 | P a g e
Cisco IP Phone 6851 Series User Guide