Draytek VigorAP 802 User Manual page 46

Auto Channel Filtered
Out List
IGMP Snooping
Isolate 2.4GHz and
5GHz bands
Isolate members with
IP
WMM Capable
APSD Capable
(for 5GHz only)
MAC Clone
(for 2.4GHz only)
After finishing this web page configuration, please click OK to save the settings.
However, some wireless stations will detect / scan the country code to
prevent conflict occurred. If conflict is detected, wireless station will be
warned and is unable to make network connection. Therefore,
changing the country code to ensure successful network connection
will be necessary for some clients.
The selected wireless channels will be discarded if AutoSelect is
selected as Channel selection mode in Wireless LAN>>General
Setup.
Click Enable to enable IGMP Snooping. Multicast traffic will be
forwarded to ports that have members of that group. Disabling IGMP
snooping will make multicast traffic treated in the same manner as
broadcast traffic.
The default setting is "Enable". It means that the wireless client using
2.4GHz band is unable to connect to the wireless client with 5GHz
band, and vice versa.
For WLAN 2.4GHz and 5GHz set with the same SSID name:
No matter such function is enabled or disabled, clients using

WLAN 2.4GHz and 5GHz can communicate for each other if
Isolate Member (in Wireless LAN>>General Setup) is NOT
enabled for such SSID.
Yet, if the function of Isolate Member (in Wireless

LAN>>General Setup) is enabled for such SSID, clients using
WLAN 2.4GHz and 5GHz will be unable to communicate with each
other.
The default setting is "Disable".
If it is enabled, VigorAP will isolate different wireless clients according
to their IP address(es).
To apply WMM parameters for wireless data transmission, please click
the Enable radio button.
APSD (automatic power-save delivery) is an enhancement over the
power-save mechanisms supported by Wi-Fi networks. It allows
devices to take more time in sleeping state and consume less power
to improve the performance by minimizing transmission latency.
The default setting is Disable.
Click Enable and manually enter the MAC address of the device with
SSID 1. The MAC address of other SSIDs will change based on this
MAC address.
40