Cisco ONS 15454 Installation Instructions Manual page 22

NTP- A20 Replace the Front Door
Attach the terminal lug.
b.
Using the open-end wrench, attach and tighten the #4 Kepnut (49-0337-01) on the terminal lug.
c.
Note
Step 4 Replace the left cable-routing channel.
Step 5 Using a Phillips screwdriver, insert and tighten the screws for the cable-routing channel.
Figure 2-2
Figure 2-2
Step 6 Swing the door closed.
Note
Stop. You have completed this procedure.
Cisco ONS 15454 Procedure Guide, R8.0
2-22
To avoid interference with the traffic (line) card, make sure the ground strap is in a flat
position when the door is open. To move the ground strap into a flat position, rotate the
terminal lug counterclockwise before tightening the Kepnut.
shows the shelf assembly with the front door and ground strap installed.
Shelf Assembly with Door Ground Strap Retrofit Kit Installed
Ground strap cable
The ONS 15454 comes with a pinned hex key tool for locking and unlocking the front door. Turn
the key counterclockwise to unlock the door and clockwise to lock it.
Chapter 2 Install Cards and Fiber-Optic Cable
78-17697-01