Cisco ONS 15454 Installation Instructions Manual page 21

Chapter 2 Install Cards and Fiber-Optic Cable
NTP-A20 Replace the Front Door
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note Be careful not to crimp any fiber-optic cables that are connected to the optical cards. Some might not
have the fiber boot attached.
Step 1 Insert the front door into the hinges on the shelf assembly.
Attach one end of the ground strap terminal lug (72-3622-01) to the male stud on the inside of the door.
Step 2
Attach and tighten the #6 Kepnut (49-0600-01) using the open-end wrench
Figure 2-1
Attach the other end of the ground strap to the longer screw on the fiber guide.
Step 3
a.
78-17697-01
This procedure replaces the front door and door ground strap after
installing cards and fiber-optic cables.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-A3 Open and Remove the Front Door, page 1-6
Required
Onsite
None
Installing the Door Ground Strap Retrofit Kit
Attach the lock washer.
NTP- A20 Replace the Front Door
(Figure 2-1).
Cisco ONS 15454 Procedure Guide, R8.0
2-21