Cisco ONS 15454 Installation Instructions Manual page 14

NTP- A274 Install the FC_MR-4 Card
If you installed XCVT cards, review
Step 1
installed XC10G or XC-VXC-10G cards, review
compatibility.
Step 2 Open the card latches/ejectors.
Use the latches/ejectors to firmly slide the card along the guide rails until the card plugs into the
Step 3
receptacle at the back of the slot.
Note
Step 4 Verify that the card is inserted correctly and close the latches/ejectors on the card.
Note
Verify the LED activity:
Step 5
• The red FAIL LED turns on for 20 to 30 seconds. The ACT LED is amber for 3 to 5 seconds.
• The red FAIL LED blinks for up to 2 minutes.
• The FAIL and ACT LEDs blink once and turn off for 1 to 5 seconds.
The ACT LED turns on green.
•
Note
Note
Complete the
Step 6
the FC_MR-4 card.
Note
Step 7 Continue with the
Stop. You have completed this procedure.
Cisco ONS 15454 Procedure Guide, R8.0
2-14
If you install the wrong card in a slot, complete the
procedure on page 2-20 and install the correct card.
It is possible to close the latches/ejectors when the card is not completely plugged into the
backplane. Ensure that you cannot insert the card any further.
If the red FAIL LED does not turn on, check the power.
If you insert a card into a slot provisioned for a different card, all LEDs turn off.
"DLP-A469 Install a GBIC or SFP/XFP Device" task on page 21-57
If you need to remove a GBIC or SFP/XFP, complete the
SFP/XFP Devices" task on page
"NTP-A247 Install Fiber-Optic Cables" procedure on page
Table 2-1 on page 2-3 to determine card/slot compatibility. If you
Table 2-2 on page 2-5
"NTP-A116 Remove and Replace a Card"
21-59.
Chapter 2 Install Cards and Fiber-Optic Cable
to determine card/slot
to install GBICs on
"DLP-A470 Remove GBIC or
2-16.
78-17697-01