Cisco ONS 15454 Installation Instructions Manual page 20

NTP- A116 Remove and Replace a Card
Route the fiber-optic cables out either side of the cable-management tray through the cutouts on each
Step 6
side of the shelf assembly. Use the reversible fiber guides to route cables out the desired side.
Step 7 Close the fold-down front door when all fiber-optic cables in the front compartment are properly routed.
Stop. You have completed this procedure.
NTP-A116 Remove and Replace a Card
Purpose
Tools/Equipment
Prerequisite Procedures A card installation procedure
Required/As Needed
Onsite/Remote
Security Level
If you are not logged into CTC and you need to remove a card, remove the card as described in
Step 1
When you log into CTC, troubleshoot the mismatched equipment alarm (MEA) with the
Cisco ONS 15454 Troubleshooting Guide.
If you are logged into CTC, complete one of the following:
Step 2
•
•
Physically remove the card:
Step 3
a.
b.
Insert the new card using one of the following procedures as applicable:
Step 4
•
•
•
•
•
Step 5 As needed, continue with the
Stop. You have completed this procedure.
Cisco ONS 15454 Procedure Guide, R8.0
2-20
This procedure removes and replaces all cards housed in the ONS 15454
shelf and rack.
None
As needed
Onsite
Provisioning or higher
Complete the "DLP-A191 Delete a Card" task on page 18-63
Complete the "DLP-A247 Change an OC-N Card" task on page 19-29
it with a different OC-N card while maintaining existing provisioning.
Open the card latches/ejectors.
Use the latches/ejectors to pull the card forward and away from the shelf.
NTP-A15 Install the Common Control Cards, page 2-2
NTP-A16 Install Optical Cards and Connectors, page 2-7
NTP-A17 Install the Electrical Cards, page 2-10
NTP-A246 Install Ethernet Cards and Connectors, page 2-11
NTP-A274 Install the FC_MR-4 Card, page 2-13
"NTP-A247 Install Fiber-Optic Cables" procedure on page
Chapter 2 Install Cards and Fiber-Optic Cable
and continue with Step 3.
to delete a card and replace
2-16.
Step 3.
78-17697-01