Cisco ONS 15454 Installation Instructions Manual page 11

Chapter 2 Install Cards and Fiber-Optic Cable
Open the card latches/ejectors.
Step 2
Use the latches/ejectors to firmly slide the card along the guide rails until the card plugs into the
Step 3
receptacle at the back of the slot.
Note
Step 4 Verify that the card is inserted correctly and close the latches/ejectors on the card.
Note
Step 5 Verify the LED activity:
•
•
•
•
Step 6 If the card does not boot up properly, or the LED activity does not mimic
•
•
•
Continue with the
Step 7
necessary.
Stop. You have completed this procedure.
NTP-A246 Install Ethernet Cards and Connectors
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
78-17697-01
If you install the wrong card in a slot, complete the
procedure on page 2-20.
It is possible to close the latches/ejectors when the card is not completely plugged into the
backplane. Ensure that you cannot insert the card any further.
The red FAIL LED turns on for 10 to 15 seconds.
The red FAIL LED blinks for 30 to 40 seconds.
All LEDs blink once and turn off for 1 to 5 seconds.
The ACT or ACT/STBY LED turns on. The SF LED can persist until all card ports connect to their
far-end counterparts and a signal is present.
If the red FAIL LED does not turn on, check the power.
If you insert a card into a slot provisioned for a different card, all LEDs turn off.
If the red FAIL LED is on continuously or the LEDs behave erratically, the card is not installed
properly. Remove the card and repeat Steps
"NTP-A246 Install Ethernet Cards and Connectors" procedure on page
This procedure describes how to install the Ethernet cards (E100T-12,
E100T-G, E1000-2, E1000-2-G, G1K-4, ML100T-12, ML1000-2,
ML100X-8, CE-100T-8, and CE-1000-4).
Ethernet cards
NTP-A15 Install the Common Control Cards, page 2-2
As needed
Onsite
None
NTP- A246 Install Ethernet Cards and Connectors
"NTP-A116 Remove and Replace a Card"
Step
2 to 5.
Cisco ONS 15454 Procedure Guide, R8.0
5, check the following:
2-11, if
2-11