Table of Contents
Advertisement
wire via the PG16 gland to the dedicated earth tag (screw terminal) located on the bottom
bracket and connect the other end of the wire to a dedicated external earthing point. If
Power over Ethernet (PoE) power supply is being used, shielded CAT5 Ethernet cable is
recommended. Please ensure that your wiring avoids earth ground loops that may affect
the performance of your equipment.
NOTE
Instrument grounding is required to ensure stable performance and to limit the effects of
radiofrequency interference before installation.
The following diagram shows the terminal module layout and terminal identification as well as
the jumper locations.
Transmitter Terminals
Midas-M
20
User Manual
Advertisement
Table of Contents
