Table of Contents
Advertisement
This drill template is not to scale.
5.
a. Partially screw the fixings into the mounting surface.
b. Place the mounting bracket assembly over the screws, so they pass
through the mounting holes and then slide down to locate in the slots.
c. Tighten the screws to secure the mounting bracket assembly.
6.
a. Align the rounded corner at the lower of the main module with the similar
rounded corner at the bottom of the mounting bracket assembly
b. Slide the main module backward while pushing the main module up after
connecting with a mounting bracket so that the PCB connector and tubes
engage simultaneously.
7.
Ensure the PCB, connector, and tubes are fully engaged by firmly pushing the
main module horizontally backward on the mounting bracket assembly. DO
NOT PUSH ON THE LCD AS THIS MAY DAMAGE IT.
8.
a. Align the two fixing screws located at the bottom of the module with the
screw threads on the mounting bracket assembly.
b. Tighten the screws to secure the module to the mounting bracket
assembly.
9.
Remove the internal packing card securing the pump. Failure to remove this
packing will result in damage to the Midas-M detector.
Midas-M
NOTE
14
User Manual
Advertisement
Table of Contents
