Required Tools and Equipment
NTP-H168 Install the Front Door
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution
Be careful not to crimp any fiber-optic cables that are connected to the optical cards. Some might not
have the fiber boot attached.
Always use the supplied ESD wristband when working with a powered ONS 15310-MA SDH. Plug the
Caution
wristband cable into either of the ESD jacks, on the far left and right faceplates in the shelf.
Place the door hinge flush against the inside of the ONS 15310-MA SDH chassis flange on the left
Step 1
(Figure
Cisco ONS 15310-MA SDH Procedure Guide, R9.0
1-34
This procedure replaces the front door and door ground strap after
installing cards and fiber-optic cables.
Front-door kit (53-2617-XX)
Door hinge
•
Door striker
•
4-40 screws (8)
•
Ground cable
•
Hex nuts (2)
•
NTP-H150 Install the Shelf Assembly, page 1-5
Required
Onsite
None
1-9).
Chapter 1
Install the Cisco ONS 15310-MA SDH
78-18668-01