Positioning Detachable Blower (Power Head Assembly) - RIDGID WD1685AU0 Owner's Manual

Positioning Detachable Blower
(Power Head Assembly)
1. To remove the detachable blower from
the lid assembly, press down on the
detachable blower latch under the
detachable blower handle and lift the
blower off the lid of the Vac.
Detachable
Blower
Latch
2. To replace the detachable blower
onto the lid assembly, position the
detachable blower above the indented
area of the lid assembly. Rotate the
detachable blower down until the travel
of the unit stops.
Detachable
Blower Handle
Detachable
Blower
Molded
Leads
3. Lightly press down on the carry handle
of the detachable blower until you hear
the "snap" of the detachable blower
latch engaging the detachable blower.
The detachable blower is now latched
to the lid assembly.
Detachable
Blower Latch
4. Your new Wet/Dry Vac is ready for
use. With the Wet/Dry Vac completely
assembled and ready for use, insert
the push button end of the "Dual-Flex™
Locking" hose into the inlet of the Vac.
The hose should snap into place. To
remove the hose from the Vac, press
the release button in the hose assembly
and pull the hose out of the Vac inlet,
as shown.
Press and Pull
Release
Button
7
Detachable
Blower