Positioning Detachable Blower (Power Head Assembly) - RIDGID 1620RV0 Owner's Manual

SP6953 Ridgid 1620RV0_SP6542.qxd 1/16/15 10:00 AM Page 8
Positioning Detachable Blower
(Power Head Assembly)
1. To remove the detachable blower from
the lid assembly, press down on the
detachable blower latch under the
detachable blower handle and lift the
blower off the lid of the Vac.
Detachable
Blower
Latch
2. To replace the detachable blower onto
the lid assembly, position detachable
blower above the indented area of the
lid assembly. Rotate the detachable
blower down until the travel of the unit
stops.
3. Lightly press down on the carry handle
Detachable
Blower Handle
Detachable
Blower Latch
Detachable
Blower
Molded
Leads
4. Your new Wet/Dry Vac is ready for
Press and Pull
Release
Button
8
of the detachable blower until you
hear the "snap" of the detachable
blower latch engaging the detachable
blower. The detachable blower is now
latched to the lid assembly.
use. With the Wet/Dry Vac completely
assembled and ready for use, insert
the push button end of the Pro-Hose
into the inlet of the Vac. The hose
should snap into place. To remove the
hose from the Vac, press the release
button in the hose assembly and pull
the hose out of the Vac inlet, as
shown.
Pro-Hose
Detachable
Blower