Positioning Detachable Blower (Power Head Assembly) - RIDGID WD1660 Owner's Manual

Positioning Detachable Blower (Power Head
Assembly)
1. Locate the detachable blower of your
RIDGID wet/dry vac (removed earlier).
2. On top of the detachable blower (oppo-
site the handle side of the blower);
there is a molded plastic lead that is
used to assist assembling the unit.
Position the lead into the indented area
above the "Pull Handle".
3. Rotate the detachable blower down
until the travel of the unit stops.
4. Lightly press down on the carry handle of
the detachable blower until the power
head engages the lid. The detachable
blower is now latched to the lid assembly.
Your new wet/dry vac is ready for use.
With the wet/dry vac completely assem-
bled and ready for use, insert the push
button end of the "Tug-a-Long" hose into
the inlet of the vac. The hose should snap
into place. To remove the hose from the
vac, press the release button in the hose
assembly and pull the hose out of the vac
inlet, as shown.
Power Head Latch
Press and
Pull
9
Molded
Plastic Lead
Indented
Area
Pull
Handle
Release
Button