Accessory Storage Holder; Wet/Dry Vac Assembly - RIDGID WD1685AU0 Owner's Manual

Accessory Storage Holder

Installing Accessory Storage
Holder
1. Position rods of accessory storage
holder directly over the accessory rod
receptacles in the dust drum.
2. Slide accessory storage holder into the
accessory rod receptacles until fully
seated with holder clips locked.
Accessory Storage
Holder Clips

Wet/Dry Vac Assembly

1. Locate the lid assembly and the drum
assembly (assembled earlier).
2. Position the lid assembly with the
detachable blower handle of the unit
located above the vacuum inlet on the
dust drum.
3. To assemble the lid assembly to the
drum assembly, lower the lid assembly
onto the dust drum. Rotate both latches
down until you hear them snap over the
drum latch catches of the drum.
Detachable
Blower
Handle
Vacuum
Inlet
Removing Accessory Storage
Holder
Push in both accessory storage holder
clips and then pull straight up on the rods
of the accessory storage holder.
Accessory Storage
Holder Clips
Accessory
Storage
Holder
Accessory
Holder
Receptacles
6
Accessory
Storage
Holder
Accessory
Holder
Receptacles
Lid Assembly with
Detachable Blower
Drum Latch
Drum Catch
Inlet
Dust Drum
Assembly
Drain Cap