Factory Default Settings - NETGEAR WAC510 User Manual

Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual

Factory default settings

You can reset the access point to the factory default settings, which are shown in the
following table.
For more information about resetting the access point to its factory settings, see Return
the access point to its factory default settings on page 181.
Table 3. Factory default settings
Feature
Management and login settings
Management mode
User login URL
User name (case-sensitive)
Login password
(case-sensitive)
General system settings
Operating mode
DHCP client
NTP client
Spanning Tree Protocol
Network integrity check
802.1Q VLAN
Management VLAN
Syslog
Ethernet LLDP
UPnP
LEDs
WiFi network settings for initial setup
SSID name
Factory Default Settings and
Technical Specifications
Default Setting
NETGEAR Insight management mode
192.168.0.100
admin, nonconfigurable
password, configurable
AP mode
By default, Router mode is disabled, including NAT and the DHCP server function.
Enabled so that the access point receives an IP address from a DHCP server or router
in the network.
Enabled
Disabled
Disabled
Untagged VLAN with VLAN ID 1
VLAN ID 1
Disabled
Enabled
Enabled
Enabled
SSID for initial setup is NETGEARxxxxxx-SETUP, where xxxxxx is the last six hexadecimal
digits of the access point's MAC address.
228 User Manual