Display And Audio Settings; System I/O - Honeywell PX940 User Manual

Display and Audio Settings

To view these settings:
•
•
Display and
Audio Setting
Brightness
Idle Information
Time Format
Date Format
Menu Access
PIN
Screen Timeout
Feed Key Access
Information
Access
Volume
Note: PX940 printers are Energy Star qualified, but require the brightness set to Low and
power consumption may vary in actual application with Applicator Board or Industrial
Interface Board. Energy Star is qualified only for Non-Applicator or Non-Industrial
Interface.

System I/O

To view these settings:
•
•
System I/O
Setting
Ethernet
Wireless 802.11
Virtual COM
PX940 User Guide
From the printer Main Menu, select Settings > System Settings > Display or
Audio.
From the printer web page, click Configure > System Settings > Display or
Audio.
Description
Selects the brightness of the printer screen.
Selects the information that appears on the printer screen
when it is in Idle mode.
Selects the format used to display time on the printer.
Selects the format used to display date on the printer.
Determines if the Menu button on the printer web page is
accessible.
Sets the password that allows access to the Menu button on
the printer web page, if the Menu Access parameter is set to
Enable With PIN. Range is 4 to 16 characters.
Selects how long the printer screen stays on before the
screen saver starts.
Determines if the Feed button on the printer keypad is
enabled or disabled.
Determines if the information bar on the Main Menu is
accessible.
Sets the printer volume.
From the printer Main Menu, select Settings > System Settings > Manage I/O.
From the printer web page, click Configure > System Settings > Manage I/O.
Description
Determines if the printer is allowed to communicate using Ethernet
communications.
Determines if the printer is allowed to communicate using its 802.11
radio. Supported only if the optional Wi-Fi module is installed.
Determines if you can enable the USB port to be used as a virtual
serial port. When you change this setting, you must restart the
printer to enable the new setting.
Default
Low
IPv4 address
24 Hour
dd/mm/yyyy
Enable
1234
Disable
Enable
Enable
Off
Default
Enable
Enable
Disable
91