Table of Contents
Advertisement
Media Setting
Media Length
Clip Default
Print Mode
Peel Strength
Label Top Adjust
Label Reset
Adjust
Media Calibration
Mode
Length (Slow
Mode)
LTS Sensitivity
Level
88
Description
Sets the length of the printable area measured from one
edge of the label to the edge that is closest to the
printhead. Unit of measurement is defined in the Unit of
Measurement parameter.
Media length (X)
Determines if the printer prints items outside the
printable area of the label.
When this is set to Off, the printer returns an error if any
part of a barcode label cannot be printed because that
part extends beyond the printable area. When this is set
to On, the printer prints all barcode labels, but may also
print unreadable, incomplete labels.
Selects the printer tear off, peel off, or rewind media
mode
Selects strength the printer uses to peel the label off
from liner. Use Medium or High if the printer has trouble
to peel certain types of media.
Sets the length of media the printer feeds (positive
value) or retracts (negative value) before printing a label.
Unit of measurement is defined in the Unit of Measure
parameter. Range is -9999 to +9999.
Sets the length of media the printer feeds (positive
value) or retracts (negative value) after printing a label.
Unit of measurement is defined in the Unit of Measure
parameter. Range is -9999 to +9999.
Selects the mode the printer uses to calibrate media. Use
Slow if the printer has trouble identifying gaps or marks
in media. Use Fast with Retraction or Slow with
Retraction to retract the media and ribbon fed for
calibration back to the printer.
If Media Calibration Mode is set to Slow, the printer
prints the media length plus 10 mm. This value sets an
additional amount of media to be printed. Unit of
measurement is defined in the Unit of Measurement
parameter. Range is 0 to 3200.
Sets the sensitivity of the label taken sensor.
Default
Variable
Off
Tear Off
Low
0
0
Slow
0
0
PX940 User Guide
Advertisement
Table of Contents
