Restore Default Communication Settings From The Control Panel; Restore All Default Settings From The Control Panel; Error States - Honeywell 6824 User Manual

Restore Default Communication Settings From the Control Panel

Restore All Default Settings From the Control Panel

Error States

Error State Descriptions
Error Type
Paper empty
Paper jam
Serial I/F communication
error
Printhead temperature
error
6824 Mobile Full Page Printer User Manual
If you cannot connect to the printer, you may need to restore the default
communications settings (Baud Rate, Data Bit, Stop Bit, Parity, and Buffer
Control). Follow these steps to restore the default communications settings from
the printer control panel.
1 Press and hold READY/CLEAR, and then press POWER/SLEEP to turn the
printer off.
2 Press POWER/SLEEP to turn the printer on, and then immediately press and
hold READY/CLEAR.
3 Release READY/CLEAR. The printer automatically restarts.
Follow this procedure to restore all printer settings to their default values from
the printer control panel.
1 Press and hold READY/CLEAR, and then press POWER/SLEEP to turn the
pinter off.
2 Press POWER/SLEEP to turn the printer on, and then immediately press and
hold READY/CLEAR and PARK.
3 Release READY/CLEAR and PARK. The printer automatically restarts and
all settings are restored to the default values.
When there is a printer error, the indicators turn on or off or blink to alert you of
the error. Use the next table to understand the possible errors and how to
recover from errors.
Indicator Behavior
READY: Normal
FAULT: On
TRACTOR: Normal
READY: Normal
FAULT: Blinking every 1.2 seconds
TRACTOR: Normal
READY: Normal
FAULT: Blinking every 1.2 seconds
TRACTOR: Normal
READY: Off
FAULT: Blinking every half second
TRACTOR: On
Chapter 1 – About the Printer
Description and Recovery
Paper is not loaded in the print mechanism. To
recover, load paper.
You pressed PARK to reverse feed paper, and
the printer could not detect the end of the paper.
To recover, press PARK several more times until
the paper is out of the print mechanism, or
remove paper manually.
There is a serial parity error, framing error, or
buffer overrun error. The printer prints a question
mark '?' character. To recover, press READY/
CLEAR twice. If the error occurs again, you need
to check the serial communications parameters.
The printhead temperature is too hot or too cold
(less than -40 °C or more than 150 °C). To
recover, turn off the printer to allow the printhead
to cool down.
7