Router Label And Qr Code Label - NETGEAR Nighthawk RS400 User Manual

Nighthawk AC2300 Cybersecurity WiFi Router Model RS400
In addition to the three antenna connectors, viewed from left to right, the rear panel
contains the following components:
• Reset button. Pressing the Reset button resets the router. If you press the Reset
button for at least 10 seconds, the Power LED blinks amber and the router returns
to its factory settings.
• LAN ports. Four Gigabit Ethernet RJ-45 LAN ports to connect the router to LAN
devices.
• Internet port. One Gigabit Ethernet RJ-45 WAN port to connect the router to an
Internet modem such as a cable modem or DSL modem.
• USB 2.0 port. One USB 2.0 port to connect the router to a USB storage device that
does not require a USB 3.0 connection.
Note: The USB 3.0 port is on the front panel. You can use the USB 3.0 port to connect
the router to a USB storage device.
• Power On/Off button. Press the Power On/Off button to provide power to the
router.
• DC power connector. Connect the power adapter that came with your router to
the DC power connector.

Router label and QR Code label

The router label on the bottom panel lists the login information, WiFi network name
(SSID) and password (network key), serial number, and MAC address of the router.
Figure 3. Router label
Hardware Setup 13 User Manual