Restrictions; Updating Firmware - Buffalo BS-GS20 Series User Manual

Appendix A Specifications
Syslog Settings

Restrictions

Updating Firmware

(1) If changing the firmware to version 1.0.3.32 or earlier when the current firmware version is version 1.0.3.36 or
later and the current Settings password is longer than 8 characters, the Settings username and password will
revert to the default (the username will be "admin", and the password will be "password").
(2) If you do not save any changes on Settings after changing the firmware version to an earlier one, the username
and password will revert to the original if you upgrade the firmware to version 1.0.3.36 or later.
Example:
Ver.1.0.3.36 or later
Username: buffalo
Password: 123456789
* If you click [Apply] on any Settings page after (1), the usename and the password that had been set while
running firmware version 1.0.3.32 or earlier will remain the same after upgrading the firmware to version 1.0.3.36
or later.
Transfer Logs
IP Address
Attach Header
Configuration
Authentication
Device
System
(1) Change the firmware to
an older version.
(2) Change the firmware to
a newer version without
saving any changes on
Settings.*
87
Disabled
0.0.0.0
MAC Address and System Name
Notice + Detail
Notice + Detail
Notice + Detail
Notice + Detail
Ver.1.0.3.32 or earlier
admin
Username:
password
Password: