Chapter 2 Settings
Static Routing Table
Setting
Static Routing Table
SNMP Settings
To use SNMP, SNMP monitoring software is needed.
SNMP Community Table
Configure SNMP community table.
Community Name
Get
Set
Trap
Add the static routing setting to the table by entering the following items. Up to
32 static routes can be created.
Network
Enter the IP address of the network that you need to configure the static routing
for.
Subnet Mask
Enter the subnet mask of the network.
Gateway
Enter the IP address of the gateway to reach the specified network.
Displays the static routing information.
Enter the community name. You may enter up to 31 alphanumeric characters,
hyphens, and underscores.
If checked, community members are allowed to read the switch's SNMP
information.
If checked, community members are allowed to write the switch's SNMP
information.
If checked, communication members can receive SNMP traps.
22