Chapter 2 Settings; Menu - Buffalo BS-GS20 Series User Manual

Chapter 2 Settings

Chapter 2 Settings
Refer to the "Open Settings" section in chapter 1 to access Settings.

Menu

System Information
Basic
System
VLAN Settings
VLAN
VLAN Ports
L2/L3 Settings
Routing
Static Routing
(L3 mode only)
SNMP Community Table
SNMP Host Table
SNMP
SNMP Trap
SNMPv3 User
LLDP Properties
LLDP Port
LLDP LLDP-MED Port
Neighbor Table
Static MAC Filtering
Dynamic MAC Filtering
MAC Addresses Convert MAC Address
Static MAC Address
MAC Address Aging
Status
Port Settings
Speed/Mode Settings
Administration Account
System Security Access Management
Certificate
Date & Time
Status
PoE
PoE Profiles
(PoE-compatible
switches only)
Power Profiles
Advanced
Displays the switch's information.
Configure the switch's name, location, and contact.
Confirm VLAN status and create new VLAN. This switch's IP
address can also be configured on this page.
Configure PVID (Port VLAN ID).
Switch between L2 mode and L3 mode.
Configure the gateway to access the specific destination.
Configure SNMP community table.
Configure SNMP host table.
Configure SNMP trap.
Configure SNMPv3 user information.
Configure LLDP.
Configure LLDP for each port.
Configure LLDP-MED for each port.
Displays the information of LLDP-compatible products
connected to the switch.
Configure static MAC address-based filtering.
Configure dynamic MAC address-based filtering.
Add dynamic MAC addresses to the static MAC address table to
filter them in static MAC filtering.
Register static MAC addresses to the MAC address table.
Configure MAC address aging time.
Displays port status.
Configure transmission rate and flow control for each port.
Configure administration username and password.
Configure each administration interface.
Configure certificate.
Configure date and time by using SNTP or manually.
Displays PoE status.
Configure PoE settings.
Configure power saving schedules.
13