Mirroring; Spanning Tree Protocol; Stp Settings - Buffalo BS-GS20 Series User Manual

Chapter 2 Settings

Mirroring

Configure to monitor the traffic (copy the contents of communication from source to destination).
Enable
Source Port
Destination Port

Spanning Tree Protocol

STP Settings

Configure STP settings.
STP Version
BPDU Forwarding
(Only when STP is disabled)
Hello Time
Max Age
Forward Delay
Max Hop Count
(MSTP only)
Bridge Priority
MST Configuration Name
(MSTP only)
MST Revision Level
(MSTP only)
Configuration Digest
(MSTP only)
MSTI Settings
(MSTP only)
Check to enable mirroring.
Select ports to be monitored.
Select ports to monitor the traffic.
Select a STP version from STP, RSTP or MSTP.
Note: MSTP cannot be enabled when LDF is enabled. To disable LDF, navigate to
[Advanced] - [Loop Prevention].
Enable to forward BPDU frames when STP is disabled.
Enter the interval of BPDU transmission when this switch is the root bridge.
Enter the maximum time that passes before trying to reconfigure when this
switch doesn't receive BPDU.
Enter the time spent in the status changes (listening-learning-forwarding) of the
switch before forwarding packets.
Specify the maximum hop count of BPDU.
Enter the priority of this switch for selecting the root bridge.
Enter an MST region name. The same name should be configured for all devices
that belong to the same region.
Configure MST revision. The same value should be configured for all devices that
belong to the same region.
Displays the MSTI status as MD5 digest message.
To add MSTI ID, enter the MSTI ID and bridge priority, select VLAN ID(s) to belong
to, then click [Add].
56