Table of Contents
Advertisement
4.1
Section Overview
About this section
Subsection
4.1
4.2
4.3
Introduction
Preconfiguration
assumptions
Version needed for
configuration
10/01
Section 4 – Configuration
This section provides general information for various software
configuration procedures for the FSC Safety Manager (FSC-SM) system.
Topics included in this section are:
Section Overview ...................................................................................... 47
Configuration at FSC User Station ........................................................... 48
Configuration at TPS Universal Station .................................................... 49
There are three main areas which need to be configured to properly use the
FSC Safety Manager within the TotalPlant Solution (TPS) system. These
are the following:
• FSC Functional Logic Diagrams (FLDs) programming,
• Configuration of the FSC-SM at the FSC user station, and
• Configuration of FSC-SMM points at the TPS Universal Station (US).
This section assumes the following steps have been completed:
• The FSC user station hardware (i.e. cabling) has been properly installed
and connected.
Refer to the wiring section of this manual.
• The FSC user software (FSC Development System or FSC Navigator)
has been successfully loaded onto the PC.
Refer to the FSC Software Manual.
In order to successfully configure the FSC-SM system, you will need to be
using release 42x , 5xx or 600 of the FSC software and release 53x or 62x
for the TotalPlant Solution (TPS) system.
FSC Safety Manager Installation Guide
Topic
See Page
47
Hide quick links:
Advertisement
Table of Contents
