Ucn Connections - Honeywell FSC-SM Installation Manual

2.8

UCN Connections

Node address
selection
UCN installation
10/01
Unlike other UCN devices, the UCN node address is configured at the
FSC user station (using the FSC Development System software and FSC
Navigator software), and becomes slot-dependent.
The installation procedure and cabling information can be found in the
UCN Site Planning and Installation manual in the UCN Site Planning and
Installation binder.
Figure 2-6 illustrates a typical UCN installation. Connection of the UCN
system is made at the front panel of the FSC Safety Manager Module.
For detailed information regarding the connection of the
ATTENTION
UCN to the FSC Safety Manager, refer to Subsection 2.5 — Wiring and
Cabling Installation under the topic, "FSC-SMM Cabling," in this
document.
FSC Safety Manager Installation Guide
Continued on next page
39