Figure 1-11 Lifting Equipment By Mobile Lifter Of Crane - Part 2; Table 1-6 Roller Method Considerations - Honeywell FSC-SM Installation Manual

1.4 Unpacking and Placement,
Roller method
18
As illustrated in Figure 1-12, using the roller method the FSC Safety
Manager is moved to its final destination by placing pipe rollers under a
transport skid made of angle iron. Table 1-6 lists special considerations
regarding the use of the roller method to move the equipment.
Table 1-6 – Roller method considerations
Number
1 Use one of the previous methods to move the cabinet to a location
where rollers are to be used.
Install the angle iron transport skid as in the mobile lifter method.
2
Place 12 mm (1/2 inch) pipes under the transport skid as in Figure
3
1-12.
ATTENTION
cabinet.
Roll the cabinet to its final location.
4
ATTENTION
skid at all times.
When the cabinet is near the final location, tilt it and pull out the
5
pipes, the middle one last.
6 Dismantle the transport skid and position the cabinet manually to
the exact final location.
Figure 1-12 – Lifting equipment by mobile lifter of crane — part 2
Angle iron
supports
FSC Safety Manager Installation Guide
Continued
Consideration
The load must be on the angle irons, not the
At least three pipes must be under the transport
2.5 cm (1 in) pipes (minimum)
Continued on next page
10/01