Set Pc Port Configuration Field; Ipv4 Setup Menu Options - Cisco Unified 6921 Administration Manual

Set PC Port Configuration Field

Set PC Port Configuration Field
Procedure
Step 1
Unlock network setup options.
Step 2 Scroll to the PC Port Setup option and then press Edit.
Step 3 Scroll to the setting that you want and then press Select.
Step 4 To configure the setting on multiple phones simultaneously, enable the PC Port Remote Configuration in the
Enterprise Phone Configuration (System > Enterprise Phone Configuration).
Note

IPv4 Setup Menu Options

The IPv4 Setup menu is a submenu of the Network Setup menu. To reach the IPv4 Setup menu, select the
IPv4 option on the Network Setup menu.
The following table describes the IPv4 Setup menu options.
For information about the keys you can use to edit options, see the
Table 2: IPv4 Setup Menu Options
Option
DHCP
IP Address
Subnet Mask
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications
Manager 10.0 (SCCP and SIP)
8
If the ports are configured for PC Port Remote Configuration in Unified Communications Manager,
the data cannot be changed on the phone.
Description
Indicates whether the phone has DHCP
enabled or disabled.
When DHCP is enabled, the DHCP server
assigns the phone an IP address. When
DHCP is disabled, the administrator must
manually assign an IP address to the phone.
For more information, see
on page
Internet Protocol (IP) address of the phone.
If you assign an IP address with this option,
you must also assign a subnet mask and
default router. See the Subnet Mask and
Default Router options in this table.
Subnet mask used by the phone.
Edit Values, on page
DHCP Usage,
12.
Cisco Unified IP Phone Settings
3.
To Change
Set DHCP Field, on page 9
Set IP Address Field, on page
10
Set Subnet Mask Field, on page
10