Cisco Unified 6921 Administration Manual page 5

Cisco Unified IP Phone Settings
Option
Operational VLAN ID
Admin. VLAN ID
PC VLAN
SW Port Setup
Description
Auxiliary Virtual Local Area Network
(VLAN) configured on a Cisco Catalyst
switch in which the phone is a member.
If the phone has not received an auxiliary
VLAN, this option indicates the
Administrative VLAN.
If neither the auxiliary VLAN nor the
Administrative VLAN are configured, this
option defaults to a VLAN ID of 4095.
Auxiliary VLAN in which the phone is a
member.
Used only if the phone does not receive an
auxiliary VLAN from the switch; otherwise
it is ignored.
Allows the phone to interoperate with 3rd
party switches that do not support a voice
VLAN. The Admin VLAN ID option must
be set before you can change this option.
Speed and duplex of the network port. Valid
values:
• Auto Negotiate
• 1000 Full: 1000-BaseT/full duplex
(Supported only for Cisco Unified IP
Phone 6945.)
• 100 Half: 100-BaseT/half duplex
• 100 Full: 100-BaseT/full duplex
• 10 Half: 10-BaseT/half duplex
• 10 Full: 10-BaseT/full duplex
If the phone is connected to a switch,
configure the port on the switch to the same
speed/duplex as the phone, or configure both
to auto-negotiate.
If you change the setting of this option, you
must change the PC Port Configuration option
to the same setting.
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager
Network Setup Menu
To Change
Display only—Cannot configure.
The phone obtains its Operational
VLAN ID via Cisco Discovery
Protocol (CDP) from the switch to
which the phone is attached. To
assign a VLAN ID manually, use
the Admin VLAN ID option.
Set Admin VLAN ID Field, on
page 7
Set PC VLAN Field, on page 7
Set SW Port Configuration Field,
on page 7
10.0 (SCCP and SIP)
5