Table of Contents
Advertisement
Installation and Technical Manual for the
Limitless™ Multi-Protocol Receiver, WMPR Series
Figure 34. Node Update Rate - Update Rate in Pro-
cess
The screen will then change to show the current Update Rate
that is being used in the Limitless™ switch or analog sensor
(see Figure 35). The update rate options for the different Series
are as follows:
WPS Series: 0.1s, 0.25s, 0.5s, 1s, 5s, 10s, 30s, or 90s
WBX Series: 1s, 5s, 10s, 30s, or 90s
You can then scroll "Up" or "Down" to the desired Node Update
Rate and touch "Start" to initiate the change in Rate which will
lead to the display in Figure 36 momentarily before returning to
the previous screen display with the updated Rate; Figure 35:
Figure 35. Node Update Rate - Update Rate Dis-
played
Figure 36. Node Update Rate - Changed Update Rate
In-Process
20 sensing.honeywell.com
Note: If the particular Node # that you are trying to update does
not have update rate capability, the screen will display "Node
Rate N/A".
6.11 | Node LCD Display Mode
Figure 37. Node LCD Display Mode
The NODE LCD DISPLAY TIME Mode (see Figure 37) can be ac-
cessed by touching the "NODE LCD DISPLAY" function button
as displayed in the Configuration Menu (see Figure 21). Once
you are in the NODE LCD TIME Mode you can choose any of
the 14 node numbers to update by scrolling "Up" or "Down" to
the desired Node number and then touching "Enter".
The screen will display the following (see Figure 38):
Figure 38. Node LCD Time - Update of Time In-Pro-
cess
NOTICE: If the WPS Sensor is power cycled (battery removed
and replaced), the LCD time will revert to the factory setting of
99 % on.
The screen will then change to show the current LCD Time that
is being used in the Limitless™ analog sensor (see Figure 39).
The LCD Time options are as follows:
WPS Series: 0%; 99%; 60s, Off 60s; 30s, Off 30s; 15s, Off
15s; 10s, Off 10s; 5s, Off 5s
ISSUE B
32309669
Advertisement
Table of Contents
