Table of Contents
Advertisement
Installation and Technical Manual for the
Limitless™ Multi-Protocol Receiver, WMPR Series
2.5 | Operational Characteristics
2.5.1 | Update Rate vs. Node Quantity
To ensure suitable performance the tables below define the
maximum number of nodes that are allowed with all nodes
being at the defined Update Rate:
Table 8. WPS Series Sensors Update Rate
Update Rate (seconds)
0.1
0.25, 0.5
> 1
Table 9. WBX Series Switches Update Rate
Update Rate (seconds)
> 1
Limitless™ WLS, WGLA, WOI Series switches cannot have the
update rate changed and are factory set at 30 seconds; number
of nodes: 14.
2.5.2 | Update Rate vs. RF Lost Indication
Table 12 displays the approximate amount of time it takes
for the WMPR to indicate a Node Lost RF with respect to the
Update Rate that the Node is set to.
Table 10. Update Rate vs. RF Lost Indication
Update Rate (sec)
0.1
0.25
0.5
1
5
10
30
90
2.6 | EMC Specifications
The latest applicable EMC Standards are as follows:
•
EN 300 328, V1.8.1
•
EN 61326-1 (2013)
•
EN 301 489-1, V1.9.2
•
EN 301 489-17, V2.2.1
6 sensing.honeywell.com
# of Nodes
4
6
14
# of Nodes
14
RF Lost Indication (approx. sec)
0.5
1
2
5
18
45
120
360
2.7 | Environmental Specifications
Table 11. Environmental Specifications
Item
Operating temperature
Storage temperature
Operating humidity
Shock
Vibration
2.8 | Weight
All versions of the WMPR Series Receiver have an approximate
weight of 215 g [7.5 oz]. This weight does not include mounting
brackets/plates, remote cables, or antennas.
2.9 | Antenna Connection
Antennas connect to an RP-SMA male connector on the upper
surface of the WMPR. Alternatively, a remote antenna and/or a
lightning arrestor may be connected to the RP-SMA connector;
when ordered without any antenna fitted to the WMPR product.
2.10 | Agency Compliance Statements
2.10.1 | FCC Compliance Statements
•
This device complies with Part 15 of FCC Rules and
Regulations. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference
and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
•
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used
in accordance with these instructions, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference in which case the
user will be required to correct the interference at his/
her own expense.
32309669
Specification
-20 °C to 70 °C [-4 °F to 158 °F]
-20 °C to 70 °C [-4 °F to 158 °F]
0 %RH to 100 %RH
IEC 60068-2-27; half sine, 10 g,
6 ms, 3 axis
IEC 60068-2-6; 10-500 Hz w/ 0.35
mm – peak-to-peak, 58-500 Hz – 5 g
ISSUE B
Advertisement
Table of Contents
