Figure 26. Pairing In Progress; Figure 27. Join Network Notice (Switch); Figure 28. Join Network Notice (Analog Sensor); Table 20. Pair Mode - Honeywell Limitless WMPR Series Installation And Technical Manual

Multi-protocol receiver
Table of Contents

Advertisement

Installation and Technical Manual for the
Limitless™ Multi-Protocol Receiver, WMPR Series

Table 20. Pair Mode

Step
Action
Completely read this procedure before starting in
1
order to understand the timing of events that need
to be performed.
Limitless™ switch: Remove (if required) the screws
on then housing cover and then the cover of the
Limitless™ switch and locate the function button 8
(see Figure 3a or b) to be used in Step 4.
2
Limitless™ analog sensor: Remove (if required) the
screws on the housing cover and then the cover of
the Limitless™ sensor and locate the function but-
ton 8 (see Figure 3c) to be used in Step 4.
WMPR (at PAIR MODE screen): Touch the "Start"
Function button on the WMPR (see Figure 25) at
which time the display will show the following indi-
cating it has entered the pairing mode.

Figure 26. Pairing In Progress

3
Limitless™ switch or analog sensor: Within a 30 sec-
ond interval of Step 3, depress the function button
8 and hold depressed for more than five seconds
4
but less than 12 seconds at which time the orange
or green 7 LED turns on (see Figure 3a, b, or c).
While in pairing mode, the orange or green led will
flash.
18 sensing.honeywell.com
WMPR: Successful pairing will be indicated by the
screen displaying the following:

Figure 27. Join Network Notice (switch)

If it is a Analog sensor; wait up to 45s for the indica-
tion that the Node LCD screen has been verified as
indicated by the screen displaying the following:
5
Figure 28. John Network Notice (analog sensor)
You then must touch the "HOME" function button to
return to the CONFIGURATION MENU.
WMPR: Unsuccessful pairing will be displayed on
the screen as "Node Pairing Failed!" or "Not Paired!"
You will need to navigate to the "Node Status" or
"Node Information" menus to confirm proper pairing
6
between the Limitless™ switch or analog sensor and
WPMR.
Repeat Steps 2-7 to add additional Limitless™
switches or analog sensors. Up to 14 Limitless™
7
switches or analog sensors can be paired to a single
WMPR.
ISSUE B
32309669

Advertisement

Table of Contents
loading

Table of Contents