Table of Contents
Advertisement
Installation and Technical Manual for the
Limitless™ Multi-Protocol Receiver, WMPR Series
6.9 | Purge Mode
Figure 29. Purge Mode
The PURGE MODE (see Figure 29) can be accessed by touch-
ing the "PURGE" function button as displayed in the Configura-
tion Menu (see Figure 21). Once you are in the PURGE MODE
you can choose ALL or any of the 14 node numbers to purge by
scrolling "Up" or "Down" to the desired Node number and then
touching "Start".
NOTICE: A factory reset should be performed on the WPS unit
, as well. See "Restore to Factory Defaults" in the WPS Installa-
tion and Technical Manual.
The screen will display the following; Figure 30:
Figure 30. Purge Mode - Purge Update Sent
After successful purging the screen will display the following;
Figures 31 & 32:
Figure 31. Purge Mode - Single Node Being Purged
Figure 32. Purge Mode - Multiple Nodes Being
Purged. Example #2 and #5 Nodes Being Purged
You must touch the "HOME" function button to return to the
CONFIGURATION MENU.
6.10 | Node Update Rate Mode
Figure 33. Node Update Rate Mode
NOTICE: If the WPS Sensor or WBX Switch is power cycled (i.e.,
battery removed and replaced), the Update Rate will revert to
the DIP switch settings. See "Other User Settings" or "Update
Rate/DIP Switches" in the WPS and WBX Installation and Tech-
nical Manuals.
The NODE UPDATE RATE MODE (see Figure 33) can be ac-
cessed by touching the "NODE UPDATE RATE" function button
as displayed in the Configuration Menu (see Figure 21). Once
you are in the NODE UPDATE RATE MODE you can choose any
of the 14 node numbers to update by scrolling "Up" or "Down"
to the desired Node number and then touching "Enter".
The screen will display the following; Figure 34:
ISSUE B
32309669
Sensing and Internet of Things
19
Advertisement
Table of Contents
