Statement On Fcc And Ce Marking; General Description & System Components - Omega MWTC SERIES User Manual

1.4 Statement on FCC and CE Marking

1.4.1 FCC Marking
FCC ID: WR3-MWTC-2
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: 1.) This device may not cause harmful interference.
2.) This device must accept any interference received, including interference that
may cause undesired operation.
1.4.2 CE Marking
It is the policy of OMEGA
EMC regulations that apply. OMEGA is constantly pursuing certification of its
products to the European New Approach Directives. OMEGA will add the CE
mark to every appropriate device upon certification. For additional information
see Section 10 - Approvals & Regulatory Compliance.
1.5 General Description & System Components
1.5.1 General Description
Your Wireless Thermocouple/Connector Series features stand-alone, compact,
battery powered wireless connectors that transmit their readings back to a
host receiver up to 90 m (300') away. Each thermocouple unit is factory set to
work as a type J, K, T, E, R, S, B, N or C calibration connector. When activated
the connector will transmit readings continuously at a pre-set time interval
that was programmed by the user during the initial setup. Each unit measures
and transmits: Process Input Reading, Connector Ambient Temperature, RF
Signal Strength and Battery Condition to the host and is displayed on the PC
screen in real time using the provided software. When used with host receiver
model MWTC-REC1 data from up to 48 wireless connectors can be received
and displayed. Each unit includes free software that converts your PC into a
strip chart recorder or data logger so readings can be saved and later printed or
exported to a spread sheet file.
MWTC-D is a wireless thermocouple connector/data logger. It can record
up to 65400 process temperature data points or 32,700 process and ambient
temperature data points locally. The recorded data can be downloaded to PC
using the direct USB connection.
1.5.2 System Components
CONNECTOR/TRANSMITTER
–
TYPE
TC
TX
+
LOW
BATT
to comply with all worldwide safety and EMI/
®
WIRELESS THERMOCOUPLE CONNECTOR
MWTC
®
PRESS PRESS
SETUP I / O
Figure 1-5. System Components
Introduction
USB RECEIVER
MWTC SERIES
WIRELESS RECEIVER
®
TX
PWR
1
1-3