Table of Contents
Advertisement
This is a partial view of the TC-Central Program in operation. You will not have
any blocks receiving data until you have programmed and placed into operation
your connector/transmitters.
3.5.2 Setting up the TC-Central Program
Before you can make wireless measurements with your connector/transmitter
the TC-Central software must be configured properly. The following steps
outline how to setup your program.
3.5.3 Channel Configuration
From the "Tools" pull-down menu select "Configure"...."Channel 1". This will
open the program settings table were you can make selections on how you want
your system to operate.
1
2
5
4
6
Description Field
➀
In the Description Field you can type a reference name that is associated with the
location or process being measured by the connector/transmitter for address.
Example.. "Test Chamber 1"
Figure 3-11. Channel Configuration
Figure 3-12. Configuration Channel 1
3
Software
3
7
3-7
Advertisement
Table of Contents
