Fcc (Domestic Use: Usa & Canada); Section 10 Approvals & Regulatory Compliance - Omega MWTC SERIES User Manual

10
Approvals, Regulatory Compliance & Patent Notice
Section 10 – Approvals, Regulatory Compliance & Patent Notice
All approvals outlined in this manual are based on testing that was done with antennas
that are supplied with your wireless Series System Components. Removing and or
installing a different antenna will void the product compliance demonstrated in these
documents.
10.1 FCC (Domestic Use: USA & Canada)
FCC ID: WR3-MWTC-2
IC: 8205A-MWTC2
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: 1.) This device may not cause harmful interference.
2.) This device must accept any interference received, including interference that
may cause undesired operation.
To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation
distance of 20 cm or more should be maintained between the antenna of this device
and persons during device operation. To ensure compliance, operations at closer than
this distance is not recommended. The antenna used for this transmitter must not be
co-located in conjunction with any other antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Consult the dealer or an experienced radio/TV technician for help.
10-1
NOTE:
WARNING:
NOTE: