Setup And Configuration - Omega MWTC SERIES User Manual

4
Connector Operation

4.1 Setup and Configuration

4.1.1 Connecting Your Device
Connect the USB programming cable to your connector/transmitter unit and
also to an available USB port on your computer. See figures below. This cable
was provided in the box with your receiver unit.
For the MWTC-D, the USB cable is included with the transmitter. Simply connect
the cable to the USB connector on the side of the transmitter (you do not need to
open the unit) and into an available USB port on your PC, see Fig. 4-1.
Connecting Your Programming Cable
1
+ -
2
Figure 4-2A. Transmitter Programming Connection
3
Figure 4-2B. Transmitter Programming Connector with Cable Installed
(1) Programming Connector (2) Battery (3) Programming Cable
4-2