Choose Options Screen - Omega MWTC SERIES User Manual

4
Connector Operation
From this screen you will select the main operating settings for your connector/
transmitter. Start by selecting the address setting for this unit. (Note: Each
connector/transmitter must have a different address number than other units
in your system for proper operation). Then select the sample rate that your unit
will transmit data to the receiver.
RF Channel Selection
Here you can select from 3 channels choices, this gives you the flexibility to
change the transmitting frequency should you have interference from other
devices close to your system, or using multiple wireless receivers (MWTC-REC1
or MWTC-REC5 or MWTC-REC6).
If you have MWTC-D, click on the Data Logging Options button to set additional
parameters as follows:
Start Logging: You can start the recording process either at Power up (When the
unit is turned on), or at a preset time & date. When the unit is set for preset time
& date, it will automatically turns itself on and starts to log and or transmit at
the specified time & date.
Engineering Unit: You can select your Engineering unit from Deg F,C,K, and R.
Recording Selection: You can select from recording Process temperature or
Process & ambient temperatures.
Mode of Operation: You can select from Wireless only, Record only, or Wireless
& Recording combined.
You can also download selected data files (Up to 8 files) from the connector.
A typical data file is shown in figure 4-11. You can erase data files from the
connector.
MWTC-D can store up to 8 separate data files. When reached the end of the memory
or 8 data files, it will stop recording and the red and green LEDs will blink alternately.
In order to start the recording process again, you need to download the data files to
PC and then erase from the connector.
4-7
NOTE:
Figure 4-9.
Choose
Options
Screen