Analogue Input Module Mv Bridge Parameters - Honeywell Touchpoint Pro Technical Handbook

9.2.25 Custom Fault 'X' Detail Settings
The Fault details can be set for each of the enabled custom faults.
Access Level: Engineer
Parameter Name
Custom Event (1-5)
Name
Custom Event (1-5)
Level Max
Custom Event (1-5)
Level Min
Custom Event (1-5)
Latch
Custom Event (1-5)
Type

9.3 Analogue Input Module mV Bridge Parameters

The Analogue Input Module mV Bridge has the option to use the sensor catalogue (basic / extended), configure a custom
channel, or copy from a configured channel (basic / extended).
Note: When making changes using extended options, it is the user's responsibility to determine whether other settings have
been affected and to make any corresponding changes.
If a basic configuration is selected, only the first two screens detailed below will be used (Commission Channel and Field
Device Selection). The rest of the configuration will be programmed automatically, either from the sensor catalogue or from
the channel that is being copied.
Note: If a channel is configured from the sensor catalogue, it is possible to edit individual settings afterwards.
Note: For catalytic bead type detectors, the Touchpoint Pro controller is necessary to complete the measuring circuit.
Therefore all commissioned mV channels remain in Inhibit state until they are calibrated.
9.3.1.1 Configuring Custom Sensors
When configuring a custom sensor, it is the user's responsibility to select suitable units and ranges. TPPR does not check or
validate all possible combinations.
9.3.2 Commission Channel
Access Level: Administrator
Parameter Name
Channel ID
Channel Tag
Custom Channel
ID
Note: Channel Tag and Channel Custom ID only require Engineer level access for editing.
Part. No. 2400M2501_6
CONFIGURATION
Default Setting Value Range
'Custom Fault 1'
Maximum 20
Alphanumeric
Characters
3.0 mA 1.0 to 3.9 mA
2.0 mA 0.8 to 3.8 mA
Latching Non-Latching /
Latching
Fault Fault / Warning
Default Setting Value Range
Next available 1 to 64
'Channel <Channel
Maximum 30
ID>' Alphanumeric
Characters
'Channel <Channel
Maximum 20
ID>' Alphanumeric
Characters
Comment
This is the fault description, which will be
displayed on the 'Input Details' screen
The recommended minimum difference
between Fault Level Max and Fault Level Min
is 0.2 mA
Select whether the 'custom fault' should be
treated as a fault condition or as a warning
condition.
Comment
Can only be assigned during first time
configuration. Otherwise de-commission the
channel and re-assign another channel number
30 character location tag name. This is the main
channel description used throughout the
interface
20 character custom ID. This is displayed on the
'Channel Details' screen and in the
Configuration Report
75
Touchpoint Pro
Technical Handbook