Table of Contents
Advertisement
Using the MIDI Recorder to Record
Re-recording Part of a Recorded
Track (Overdubbing, Punch-in
Recording)
The recording operations described in the table below can be
performed on a recorded track.
Overdub
Records by adding performance data to a
Recording
recorded track, without deleting the
previously recorded data.
Punch-in
Used for re-recording of specific parts of a
Recording
song to correct errors, etc.
Use fast forward and fast reverse to navigate to the location
where you want to start overdubbing or punch-in recording,
and then start recording. If you know the start point and end
point of the section you want to re-record, you can also play
back the song and start performing at the desired location.
To perform overdubbing or punch-in
recording
1.
Press 7 SONG BANK.
2.
Use the bm number keys, bn [–] and [+], or the
bl dial to select the number of the song that
contains the track where you want to perform
overdubbing or punch-in recording.
3.
Press 8 RECORD/STOP.
This displays the recording setting screen and causes
the [RECORD] indicator to flash.
4.
Use the [1] (V) and [3] (W) bm number keys
to display "Rec Type".
5.
Use bn [–] and [+] or the bl dial to display
either of the settings below.
To perform this operation:
Overdub Recording
Punch-in Recording
This causes "MEASURE" and "BEAT" to flash in the
upper right corner of the display.
• If you want to change mixer settings while recording,
perform the procedure under "To configure mixer settings"
(page EN-64). When recording to the system track,
configure the mixer settings of each part of the SONG
SYSTEM part group. When recording to a solo track,
configure the mixer settings of the corresponding part of the
SONG SOLO part group. (For example, when recording to
Solo Track 3, configure the mixer settings of Part 3 of the
SONG SOLO part group.)
EN-96
Display this:
Over Dub
Punch In
6.
Press ck PLAY/STOP.
This starts song playback.
• Here, you could jump to step 9 of this procedure and
immediately start recording.
• To stop the overdub recording/punch-in recording
operation, press ck PLAY/STOP again. This will
cause the [RECORD] indicator to disappear from the
display.
7.
Use bsdFF and brsREW to navigate to
the location from which you want to start
recording.
• Use btk PAUSE to pause or unpause song
playback.
• After step 8, playing something on the keyboard in
step 9 will start recording. After determining the point
where you want to start recording, navigate to a
location just before it, and then advance to step 9.
8.
Press cm ACCOMP.
This causes "MEASURE" and "BEAT" to flash at high
speed in the upper right corner of the display. If playback
is paused, it becomes unpaused at this time.
• If you are recording to the system track, rhythm
operation buttons become enabled at this time.
9.
Use one of the operations below to start
recording.
• Play something on the keyboard.
• If you are performing punch-in recording, you can also
start recording by pressing cp STORE. In this case,
rests are inserted at the beginning of the song until you
start playing something on the keyboard.
This will cause the "MEASURE" and "BEAT" indicators to
stop flashing. The [RECORD] indicator also appears.
10.
When you are finished recording, press
8 RECORD/STOP.
This causes the [RECORD] indicator to disappear.
Advertisement
Table of Contents
