Casio CT-X5000 User Manual page 81

Creating an Auto Accompaniment (User Rhythm)
6.
Configure the tone and octave shift settings of
the part, if you want.
(1) Select the tone you want to use for part recording.
See "Selecting a Tone" (page EN-18).
• Only drum set tones can be selected for Drums
and Percussion parts. Drum set sounds cannot be
selected for the bass and the Chord 1 through
Chord 5 parts.
(2) Configure the part's octave shift setting.
While holding down dr OCTAVE, press the
ds TRANSPOSE [q] or [w] button.
(3) Pressing ck START/STOP here starts looped
playback of all the parts of the accompaniment
pattern you are currently editing. This means you can
monitor the effects of your settings as you configure
them.
(4) If there are recorded parts, pressing the [6] (ENTER)
bm number key will play back only the notes of the
part being edited.
• This causes the mixer part indicator of the part
being edited and the level indicator above it to
flash.
When the part being edited is a drum part
• To exit the above state, press [6] (ENTER) again .
7.
Configure playback settings of the part being
edited as desired.
• See "To configure the playback settings of a user
rhythm part" (page EN-86).
8.
Record keyboard play for the part being edited.
• See "To record keyboard play to each part" (page
EN-81).
9.
Configure the mixer settings of the part being
edited as desired.
• See "To configure mixer settings of a part being
edited" (page EN-83).
10.
Perform steps 5 through 9 for all parts.
11.
Perform steps 3 through 10 for all
accompaniment patterns.
12.
Save the edited rhythm using the procedure
under "To save a user rhythm" (page EN-85).
EN-80
Flashing
To configure only the mixer settings of an
existing rhythm and save it
1.
Select the built-in rhythm or previously-saved
user rhythm you want to edit.
• See "Selecting a Rhythm" (page EN-43).
2.
Long-press bk FUNCTION until the [EDIT]
indicator appears.
3.
Perform step 3 under "To edit an existing
rhythm and save it" (page EN-79).
4.
Perform step 5 under "To edit an existing
rhythm and save it" (page EN-79).
5.
Perform the procedure under "To configure
mixer settings of a part being edited" (page
EN-83).
6.
Perform steps 4 and 5 for all parts whose mixer
settings you want to configure.
7.
Perform steps 3 through 6 for all
accompaniment patterns whose mixer settings
you want to configure.
8.
Save the edited rhythm using the procedure
under "To save a user rhythm" (page EN-85).